AC jet was close to hitting two other aircraft: report
An Air Canada plane with 140 people on board came within 30 metres of crashing onto two of four planes lined up to take off at San Francisco International Airport last week, according to a preliminary report Canadian air safety regulators released Thursday.
The finding provided the first official accounting of how close the Air Canada plane came to causing an aviation disaster.
Instead of lining up to land on the runway, the pilot of the flight from Toronto mistakenly descended toward a parallel taxiway just to the right of where four other airliners were idling in the darkness. Taxiways are the aviation equivalent of feeder roads that planes use to roll between runways and terminals, and have different lights than runways.
Canada's Transportation Safety Board released a short summary of the July 7 incident, which U.S. authorities are still investigating.
The summary said Air Canada Flight 759 had already travelled almost half a kilometre over the taxiway before aborting the landing.
As the Airbus 320 pulled up sharply it flew 30 metres over the first two jets, about 60 metres above the third and about 90 metres over the fourth, the summary said. It then circled and landed safely.
"This was very close to a catastrophic event," said John Cox, a safety consultant and retired airline pilot.
The U.S. National Transportation Safety Board, which is heading the investigation, has not released any information and spokesman Keith Holloway said he could not comment on another agency's data.
Transportation Safety Board of Canada spokesman Chris Krepski said he could not confirm the source of the data in the document, which was released as part of a "daily notification log" of safety incidents that Canadian air operators are obliged to report to regulators.
The most likely source was Air Canada, but company spokeswoman Angela Mah would only say in an email that the airline is "investigating the circumstances and co-operating with authorities." She said because of the investigation, she could provide no more information.
Collisions on the ground are particularly dangerous because planes waiting to take off are loaded with fuel. The deadliest crash occurred in 1977 when a KLM Boeing 747 taking off in the Canary Islands plowed into a Pan Am 747 that was waiting to take off; 583 people died in the crash and fires.
There are several cases in the United States when landing planes either hit another aircraft on the ground or barely cleared one. In the instances that safety consultant Cox recalled, including several at Los Angeles International Airport, the pilots of the landing plane could not see the other airplane.
"What is so unusual about this one is the airplanes could see each other and they still got this close," Cox said. "These guys really did intend to land on this taxiway."
In audio posted on liveatc.net, which records flight communications, the pilot said he sees "some lights on the runway," apparently alluding to planes on the taxiway.
According to the report released Thursday, the plane at that point was less than a kilometre from the taxiway. It would have been flying well over 160 kilometres per hour.
"That's awful to let it go that far," said Chris Manno, an American Airlines pilot for 32 years who regularly lands in San Francisco. "Pretty egregious."
The controller assured the pilot there is no one on the runway. Seconds later, another voice – apparently one of the pilots on the taxiway – interjects, "Where's this guy going? He's on the taxiway."
Only at that point did the controller order the Air Canada jet to pull up.
Flying Colours signs agreement with Conair for Q400MR modificationsFlying Colours Corp. has signed an agreement with, Conair Group…
Bombardier reports Q4 and full year 2017 resultsBombardier has reported its fourth quarter and full year 2017…
Air Canada appoints Turner VP, maintenanceAir Canada President and Chief Executive Officer Calin Rovinescu has…
Rockwell Collins receives new ADS-B Out certification for 32 aircraft modelsRockwell Collins’ ADS-B Out Part 23 approved model list supplemental…
DTI Basic Quality Assurance - Winnipeg
March 13, 2018
DTI Basic Auditing Principles - WInnipeg
March 14, 2018
Aerial Firefighting North America 2018
March 19-23, 2018
March 21-23, 2018
DTI Basic Quality Assurance - Vancouver
March 27, 2018
AME MechanicAt PAL Airlines we are dedicated to providing air travelers…
Aircraft Maintenance EngineerAt PAL Airlines we are dedicated to providing air travelers…
Dash CaptainAt PAL Airlines we are dedicated to providing air travelers…
Quality Inspector - AviationCarry out quality inspections during the production of Diamond products.